Building In - Zanussi ZGG 646 ICN Instruction Booklet

Building In

This hob can be inserted in a built-in kitchen unit whose
depth is between 550 and 600 mm. The hob
dimensions are shown in Fig. 9.
The edge of the cut out must have a minimum distance
from the rear wall of 55 mm.
If there are side walls, or sides of the furniture unit near
the hob, the cut out edges must have a minimum
distance of 100 mm.
Hanging forniture units or hoods must be placed at 650
mm. minimum from the hob.
A = Auxiliary burner
SR = Semirapid burner
R = Rapid Burner
Fitting the hob to the worktop
Before fitting the hob into the cut out, an adhesive seal
must be fitted to the underside outside edge (Fig. 10)
of the hob. It is essential that no gaps are left in this seal
in order to prevent spillage near the hob seeping into
the cabinet below.
1) Remove the pan supports, the burners caps and
crowns and turn the hob upside down, taking care the
ignition candles are not damaged in this operation.
2) Place the sealing gasket all around the glass top
edge as shown in Fig. 10.
3) Fit the hob in the cut out and push it down until the
glass top and the working top come in touch, as shown
in Fig. 11.
FO 2109
Fig. 9
Fig. 10
FO 2107
Fig. 11
a) sealing gasket
SR
A
SR
R
Dimensions are given in millimeters
FO 2320
A
9