Door Reversal - Zanussi ZCUF99W Instruction Booklet

Door Reversal

1. Close the appliance and disconnect the appliance
from the electricity socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Reposition it and
transfer to the opposite side.
3. Support the appliance on a wooden block when it
is laid down. This will make it easier to grip under
the appliance when returning to an upright position.
4. On the upper part of the appliance. Remove the
hinge pin and replace on the other side.
5. On the lower part of the appliance. Unscrew the
hinge. Move the hinge pin and plastic cover. Secure
the hinge on the other side.
6. Raise the appliance and replace the ventilation
grille.
7. Unscrew the handle. Carefully press in the plastic
plugs on the opposite side using a punch. Secure the
handle in the plug holes. Then press the supplied
plastic plugs into the holes to which the handle was
previously fitted.
8. Put the appliance in position. Check that it stands
straight. See the section "Positioning the appliance".
Attention
After completion of the door reversing
operation, check that the door gasket adheres
to the appliance. If the ambient temperature is
cold (i.e. in Winter), the gasket may not fit
perfectly to the appliance. In that case, wait for
the natural fitting of the gasket or accelerate
this process by heating up the part involved
with a normal hairdryer on a low setting.
1
2
3
4
5
7
13
Zanussi 818 20 91-00/2