Table of Contents
Advertisement
Door reversal directions
(Fig. 3)
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out this reversal go through the following
steps:
Gently lay the freezer on its back with the top
held away from the floor by 5-8 cm (2-3 inches) of
packing.
Remove the bottom door hinge (5).
Remove the freezer door (4) by opening it and
pulling it gently downwards to remove it from the
top hinge pin (2).
Unscrew the top hinge pin (2) from the top
hinge (1) and replace it in the opposite hole on the
left hand side.
Unscrew the foot at the base (6) of the appliance
and refit it on the opposite side.
Refit the freezer door and the bottom hinge to the
left hand side.
Remove the door handle (3) and fit it on the
opposite side by removing the plastic plugs from
the fixing holes and fitting them in the vacated
holes on the opposite side. (Protect the paintwork
with masking tape).
When the bottom hinge is screwed in, a certain amount of
force is exerted on the screws.
It is therefore advisable to lubricate the screw tips before
starting this operation.
Attention
After completion of the door reversal operation,
verify that the door gasket is sealing onto the
cabinet.
7
Advertisement
Table of Contents
