Table of Contents
Advertisement
Instructions for the installer
This appliance cannot be positioned on a
base.
The following instructions are meant for a qualified
installer, in order that the operations of installation,
regulation, and service are executed according to the
existing regulations.
Before using the unit, take off the special protective layer
which protects the stainless steel and anodyzed tin
parts. Whenever changes are mode involving the
disconnection of the machine it is necessary to proceed
with maximum caution.
Positioning and levelling
In order to function normally it is imperative that this unit
is installed in a well ventilated kitchen (regarding the
installation follow the existing regulations). The appliance
is of freestanding type and must be installed according
to the existing regulations.
Feet Assembly
Before installing the cooker, it is necessary to
assemble the supplied feet.
1. Remove the hob pan supports, the burner caps and
crowns and the oven accessories.
2. Carefully lean the cooker on its back, paying attention
not to cause any damage.
3. Adjust the feet height by unscrewing the bottom part
of each foot, until you obtain the required height (height
can be adjusted from 850 to 880 mm).
4. Insert the feet into the relevant holes indicated in the
diagram.
5. Lift the cooker in vertical position. Replace the crowns,
the burner caps, the hob pan supports and the oven
accessories.
6. If necessary, adjust the cooker horizontal levelling by
turning the bottom part of the feet, until the appliance
is completely stable.
THE MANUFACTURING COMPANY DECLINES
ANY RESPONSABILITY FOR POSSIBLE
DAMAGES
RESULTING
INSTALLATION WHICH DOESN'T COMPLY
WITH THE RULES IN FORCE
FROM
AN
FO 2283
21
Advertisement
Table of Contents
