Filling With Salt - Zanussi DW 6826 Instruction Booklet

Filling with salt

If your water is "level 0" it is already soft and
therefore there is no need to use salt.
Salt must be used from level 1 upward.
Only use salt specifically designed for use in
dishwashers.
Other types of salt may reduce the efficiency of the
softener.
Only fill with salt just before starting one of the
complete washing programmes (not the Rinse and
Hold programme).This will prevent any grains of
salt or salty water, which may have been spilled,
remaining on the bottom of the machine for any
period of time, which may cause corrosion.
To fill:
To fill with salt, unscrew the cap of the salt
container.
Pour about 1 litre of water inside the container,
or until it is full (this is necessary only before
filling with salt for the first time).
Then using the funnel provided, pour in the salt
until the container is full (approx. 1.5 - 1.8 kg).
Do not worry if water over flows from the unit
when filling with salt, this is quite normal.
Replace the cap making sure that there is no
trace of salt on the screw thread or on the
gasket.
Screw on the cap tightly.
The salt container will require topping up
periodically.
The salt cap has a refill indicator window in the
centre.
A green floater is clearly visible when there is salt
inside the container, and almost disappears when
the salt has finished, (ie. every 30 - 50 washes
depending on the setting of the water softener)
reminding you to add salt.
SR06
SR11
30
PFS01GB