Operating Sequence - Zanussi DW 6826 Instruction Booklet

Operating sequence

1. Check the filters
Ensure they are clean and properly
positioned (see cleaning instructions).
2. Check that there is rinse aid
and salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
4. Ensure that the spray arms can
rotate freely.
5. Measure out detergent
Add the required amount of detergent into
the dispenser according to the Programme
chart and close the lid.
6. Close the detergent dispenser
lid
7. Close the dishwasher door
8. Set the programme
Push the programme selector dial in to
make it pop out. Then turn the programme
selector clockwise until the letter of the
programme you wish to select corresponds
with the programme marker on the control
panel.
If required press the "Economy 55°C"
button according to the instructions in
the "Washing programmes" chart (see
"Required pushbuttons").
9. Start the programme
Depress the On/Off button.
The On/Off indicator light will come on
and the machine will start.
If you wish to interrupt the wash
programme at any time press the button
again.
To restart the machine, depress the same
button again and the programme will
continue from the point where it was
interrupted.
10. At the end of the washing
programme
At the end of the washing programme the
machine stops automatically.
The On/Off indicator light remains on
until the On/Off button is depressed.
11. Switch off the dishwasher
Switch off the dishwasher by pressing the
On/Off button and open the door.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Caution
Do not open the door during the hot
phase: this may cause hot water
escape.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
37
POS01GB