Mac Users; Installation Procedure - Belkin TuneSync F5U255ea User Manual

Tunesync for ipod charge, sync, and listen to your ipod while connecting up to 5 usb devices to your computer

Table of Contents

Available languages

Installation

Mac Users

IMPORTANT NOTE: Please do not connect any USB devices

to the hub until instructed to do so in step 3 of this

1. Plug the AC adapter into a wall outlet or surge protector. Plug the DC

2. Plug the flat end (USB A connector) of the provided USB device cable

3. Attach a USB 2.0 or 1.1 device to the hub and begin using it.

Note: The hub must be connected to a USB 2.0-compliant host in order to

Installation

F5U255ea.indb 6

connector into the DC power jack found on the rear of the hub.

into the downstream port of your computer or downstream port

of another hub. Then plug the square end (USB B connector) of the

device cable into the upstream port on the rear of the hub.

function in Hi-Speed USB 2.0 mode (480Mbps data rate). If the hub is

connected to a USB 1.1-compliant host, it will operate only in low- and

full-speed mode (1.5Mbps/12Mbps).

11/8/2005 10:06:41 AM

Table of Contents

Table of Contents