Table of Contents
Advertisement
Door Reversal
1. Close the cabinet and remove the plug from the
electrical socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Reposition it and put
it on the other side.
3. Put the cabinet on a wooden board when it is laid
down. Later, when raising the cabinet, it will be
easier to grip under the cabinet thanks to the board.
4. On the upper part of the cabinet. Put the hinge pin
on the other side.
5. On the lower part of the cabinet. Unscrew the
hinge. Move the hinge pin and plastic cover. Secure
the hinge on the other side.
6. Raise the cabinet and replace the ventilation grille.
7. Change the position of the handle.
Remove the cover washers concealing the screws. If
the washers are difficult to remove, use a small, flat
screwdriver.
Then unscrew the handle.
Carefully press the plastic plugs into the holes on the
side opposite that of the door using a drift. Secure
the handle in the plug holes. If the handle is
mounted by hand, then turn the screws in the holes a
couple of times prior to securing the handle. Press
the supplied plastic plugs into the holes to which the
handle was previously fitted.
8. Put the cabinet in position. Check that it stands
straight. See the section "Positioning the cabinet".
Electrical connection
Connect the cabinet to a grounded electrical outlet.
Voltage: 230 V.
Fuse: 10 A.
Refer to the rating plate on the left inside the
cabinet.
1
2
3
4
5
7
11
Zanussi 818 18 84-01/9
Advertisement
Table of Contents
