Related Manuals for Zanussi ZC345P
Summary of Contents for Zanussi ZC345P
- Page 1 FRIGORIFICO REFRIGERATOR ZC345P ZC345R ZC395P ZC395R INSTRUCCIONES DE USO INSTRUCTION BOOKLET 8181455---00/0...
- Page 2 ....When the appliance is not in use ....Zanussi 8181455-00/0...
- Page 3 Wire shelf Glass shelf Vegitable drawer Egg tray Dairy compartment + butter box Ventilation grille Door shelf Bottle shelf Modell ZC345R, ZC345P Wire shelf Glass shelf Vegitable drawer Egg tray Dairy compartment + butter box Ventilation grille Door shelf Bottle shelf Lights when the fridge is operating.
- Page 4 Meat, fish and milk should be put in the coldest part of the cabinet. The temperature will be affecteed by: How often the door is opened How much food is stored Position of the appliance (See chapter Installation) Zanussi 8181455-00/0...
- Page 5 They are required for proper air circulation inside the cabinet. Shelves with a raised edge should be placed with the raised edge facing the rear wall of the cabinet, and thus prevent food products from touching the cooling plate. Zanussi 8181455-00/0...
- Page 6 The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented not putting warm foodstuff inside the cabinet. avoiding frequently opening the door or keeping it open too long. do not place foodstuffs directly against the cold cooling plate. Zanussi 8181455-00/0...
- Page 7 Use a bulb of the same type, E14 socket, maximum rating of 25 W. Discconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. Zanussi 8181455-00/0...
- Page 8 Carefully bend them if they do. If the cushion spacers (between the cabinet wall and pipes) come loose, put them back in place again. Carefully follow the instructions in the chapter ”Installing the cabinet”. See Guarantee Conditions on the Registration Card. Zanussi 8181455-00/0...
- Page 9 1. Remove the handel and the frame of the side (mm) (mm) (mm) where the handle is fitted. 4max ZC345P 1436 2 Loosen the screws of the other frames. 4max ZC395P 1636 3 Adjust the panel and screw it in place.
- Page 10 10 mm to allow the door to open enough so that the shelves can be removed. Connect the cabinet to a grounded electrical outlet. Voltage: 230 V. Fuse: 10 A. Refer to the rating plate on the left inside the cabinet. Zanussi 8181455-00/0...
- Page 11 Then press the supplied plastic plugs into the holes to which the handle was previously fitted. 7. Put the cabinet in position. Check that it stands straight. See the section ”Positioning the cabinet”. Zanussi 8181455-00/0...