Door Reversal - Zanussi ZFC244-1 Instruction Booklet

Door reversal

Before starting work, unplug the appliance. To reverse
the opening direction of the door proceed as follows:
remove the lower hinge (3), pin (1) and foot (2);
unscrew the front left foot and screw it back in on the
opposite side;
remove the two screws which mask the holes for
fixing the hinge from the front left hand side;
slide out the door from pin (D), unscrew the latter and
then screw it down into the hinge provided on the
opposite side;
remove the two plugs, to reveal the holes for the hinge
pivots, and remount them on the other side;
reassemble the door;
refit the lower hinge (turning it through 180 ), the
threaded insert, the pin and the foot on the opposite
side, as shown in the figure.
Unscrew the handle and refit it on the opposite side.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the cabinet.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
D590
2
D299
D336
Fig. 3
D
Fig. 4
1
3
2
Fig. 5
17