Editing Programs - DOD TEC8 Owner's Manual

1) by pressing the Bank select footswitch followed by footswitch 1, 2, or 3.
2) by turning the Data wheel in Program mode.
To Select Programs using the footswitches:
1) After you power up, the TEC8 defaults to Program mode. Select a Bank
by pressing the Bank selector footswitch. The display shows the select-
ed bank number on the left side of the display and a dash on the right.
The display might look something like this:
or
1
2
NOTE: If a new Program number is not selected within 5 seconds after
pressing the Bank select button, the display returns to its previous setting.

Editing Programs

As you become more familiar with the TEC8, you may find that you need
to modify certain Programs to better fit your needs. Fortunately, the TEC8
is flexible enough to give you everything you need without being difficult
to program.
DATA
6
Signal Processing Signal Processing Signal Processing
2 _
2) Press footswitch 1, 2, or 3. The dash in the display
3
changes to show the number of the Program you
selected. The display might look something like this:
2 3
The following procedure is an example of how to modify your
Programs. Suppose that Program 63 (which has an Arena reverb,
250 ms Mono Delay, a Tremolo, Noise Gate, EQ, and
Compression) sounds close to what you want, but you want a
300 ms delay with low feedback instead. Here's how to change
it:
1) Use the Data wheel, or the Bank and Program selector
footswitches to select Program 63.
2) Press the Delay effect Group button. The Mono Delay Group
Status LED begins flashing and the display reads:
2 5