Zanussi Electrolux W1207 Instruction Booklet page 12

• The machine has completed the programme: this is
indicated by a blinking zero. The zero will reappear
when you switch the machine on, unless the
previous programme has been erased by means of
the SKIP RESET button.
Important!
The first time you use the machine, when you switch
it on, it may display a blinking zero. This is due to the
fact that the machine has performed a washing cycle
during the manufacturer's inspection tests, and this
cycle has not been erased after its completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour, and then, when
remain the last 2 hours each 30 minutes.
You can delay the start of the selected programme
by up to 23 hours in one hour intervals.
• An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 27).
10 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the machine. The light above the button will stop
flashing and remain lit.
If you have selected a delay time by means of
button 12, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progressis interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important!
You must set the machine to PAUSE before you
make any change in the programme in progress.
12