Advertisement
Dismounting
Before the control panel is removed, the mains supply
must be disconnected, then:
- the bottom of the enclosure (intermediate base)
must be removed or the plate at the front of the
control panel unscrewed.
- the retaining springs (B) on each side of the control
panel must be depressed and the box slid forward.
Operation
1. Cooking area front left-heat control knob
2-circuit
2. Cooking area rear left-heat control knob
3. Cooking area rear right-heat control knob
2-circuit
4. Cooking area front right-heat control knob
2-circuit regulator
The switches (1) and (3) are additional for 2-circuit
cooking plates.
The switches can only be turned to the right.
With the combination of the panel-mounting control
panel and a glass ceramic cooking field equipped with
2-circuit heater, this feedback switches can be used
to switch on either one or both heating circuits of the
2-circuit cooking zones.
Connection of the second heating circuit is performed
by turning the adjustment toggle beyond the end stop
(perceptible engagement). The second heating circuit
is switched off by turning back the toggle to its zero
position.
For feedback control of the entire cooking field, the
same adjustment scale applies as for the quick coo-
king field.
This description is only valid for glass ceramic cooking
fields with 2-circuit heaters.
If the control panel is coupled to a cast cooking trough
or a glass ceramic cooking field without 2-circuit
heater, the end stop switch of the feedback switch has
no function. The same description then applies as for
the «normal» control switch, except that the switch
does only be turned on to the limit stop.
6
1
3
2
0
4
Advertisement
