Unloading The Dishwasher - Zanussi ZDI 311 User Manual

function "indicator light illuminates. This means
that the function is active.
To deactivate the function press the same but-
tons again until the indicator light correspond-
ing to the "3 in 1" symbol turns off.
IMPORTANT!
If the drying results are not satisfactory we sug-
gest that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• The activation/deactivation of the rinse aid
dispenser can only be possible with the "3 in
1 function" active.
Activation/deactivation of the
rinse aid dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Press simultaneously buttons B and C, un-
til the indicator lights of buttons A, B, and
C start flashing.
3. Press button B, the indicator lights of but-
tons A and C turn off while the indicator
light of button B goes on flashing.

Unloading the dishwasher

• Hot dishes are sensitive to knocks.
The dishes should therefore be allowed to
cool down before removing from the appli-
ance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping from
the upper basket onto the dishes in the lower
one.
18
4. To activate the rinse aid dispenser, press
button B again, the end of programme in-
dicator light illuminates, indicating that the
rinse aid dispenser has been activated.
5. To memorise the operation, switch off the
dishwasher by pressing the On/Off button.
6. To deactivate the rinse aid dispenser
again, follow the above instructions until
the end of programme indicator light turns
off.
IMPORTANT!
If you decide to turn back to the use of standard
detergent system we advise that you:
1. Deactivate the 3 in 1 function.
2. Fill up the salt container and the rinse aid
dispenser again.
3. Adjust the water hardness setting to the
highest setting and perform 1 normal wash-
ing programme without loading any dishes.
4. Adjust the water hardness setting accord-
ing to the hardness of the water in your
area.
5. Adjust the rinse aid dosage.
• Water may appear on the sides and the door
of the dishwasher as the stainless steel will
eventually become cooler than the dishes.
CAUTION!
When the washing programme has finished, it
is recommended that the dishwasher is un-
plugged and the water tap turned off.