Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi WE1200
Summary of Contents for Zanussi WE1200
- Page 1 WASHER-DRYER 세탁건조기 WE 1200 USER MANUAL 사용 설명서 132996530...
- Page 2 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged.
-
Page 3: Table Of Contents
Contents Warnings Maintenance Door seal Disposal Bodywork Detergent dispenser drawer Tips for environmental protection 5 Drain filter Water inlet filter Technical specifications Emergency emptying out The dangers of freezing Installation Unpacking Something not working? 27-28 Positioning Water inlet Water drainage Electrical connection Your new washer-dryer Description of the appliance... -
Page 4: Warnings
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Use only the recommended quantities of fabric softener. An excessive amount could damage the • All internal packing must be removed before using laundry. -
Page 5: Disposal
Child safety • Make sure that children or pets do not climb into the drum. • Children are often not aware of how dangerous • When the appliance is to be scrapped, cut off the electrical appliances can be. When the machine is electrical supply cable and destroy the plug with working, children should be carefully supervised the remaining cable. -
Page 6: Technical Specifications
Technical specifications DIMENSIONS Height 85 cm Width 60 cm Depth 57 cm WASHING DRYING MAXIMUM LOAD Cotton 6.5 kg 3 kg Synthetics 3 kg 2 kg Delicates 3 kg Woollens 2 kg SPIN SPEED 1200 rpm max. POWER SUPPLY VOLTAGE/FREQUENCY 220 V/60 Hz TOTAL POWER ABSORBED 2050 W... -
Page 7: Installation
Installation Unpacking 7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet. All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. -
Page 8: Water Drainage
The inlet hose is provided with a water stop device, The drain hose must not be kinked. Run it along the which protects against damage caused by water floor; only the part near the drainage point must be leaks in the hose which could develop due to natural raised. -
Page 9: Your New Washer-Dryer
Your new washer-dryer This new washer-dryer meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. • The possibility of selecting the temperature, spin speed and all the options offered by this machine gives you truly “customised”... -
Page 10: Use
Control panel 1 ON/OFF button 4 TEMPERATURE button Press this button to switch the machine on. Press this button repeatedly to increase or decrease Press the ON/OFF button again to switch the the temperature, if you want your laundry to be washed machine off. - Page 11 To complete the cycle, choose one of the following 7 ECONOMY button options: Use this button for normally soiled cottons or • Draining and spin: synthetics without stubborn stains and with washing - Press the START/PAUSE button . The temperatures more than 40º C. machine will drain the water, then spin the The appliance will automatically reduce the laundry at the maximum speed provided for the...
- Page 12 • Duration of washing programme in hours • Delay start, a time value indicated in hours and selected by means of the relevant button. and minutes, after you have selected a programme. The delay time is displayed for 3 seconds, then the While the programme is running (after you have duration of the selected programme reappears.
- Page 13 Example: 10 START/PAUSE button In this case, only the This button has three functions: spin (at the speed • Start: after you have selected the desired provided for the programme and options, press this button to start selected type of fabric) the machine.
- Page 14 13 Programme phase indicator 12 DELAY button lights This button makes it possible to delay the starting of the programme by up to 24 hours. The delay you When you select a programme, the lights relevant to have selected is shown on the display for about 3 the phases that form the programme light up.
-
Page 15: Washing Hints
Laundry weights Washing hints The following weights are indicative: bathrobe 1200 g Sorting the laundry napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. Sort the laundry as follows: sheet 500 g whites, coloureds, synthetics, delicates, woollens. -
Page 16: Detergents And Additives
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly. -
Page 17: Drying Hints
Drying symbols on garment labels Drying hints Always look at the garment label to check whether As a dryer, the machine works on the condensation garments can be machine dried. principle. The following symbols refer to drying: Therefore, the water tap must be open and the drain hose must drain water into a sink or into Machine drying is usually possible the drain pipe, even during the drying cycle. -
Page 18: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not... -
Page 19: Operating Sequence
4. Switch the machine on Operating sequence To switch the machine on, press the ON/OFF button : the mains-on light comes on. The display will show three blinking dashes or a Wash only blinking zero. Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. -
Page 20: Select The Delay Time
6. Select the temperature Depress the ECONOMY button if you have to wash normally soiled cottons or synthetics. Press the TEMPERATURE button if you wish to select a temperature value different from the one proposed by the machine. The relevant light will light up. 9. -
Page 21: End Of Programme
11. How to change a programme Pay attention to the level and temperature of the water in the machine! during its cycle When you close the door and press the ON/OFF Before you make any change, you must pause the button again, the machine will resume the machine by pressing the START/PAUSE button. -
Page 22: Drying Only
Drying only Automatic washing and drying (NON-STOP programme) Warning! Do not exceed the maximum laundry loads: Warning! For NON-STOP programmes, it is also - 3 kg for linen and cottons essential not to exceed the maximum load sizes of 2.5 kg or 3 kg for cotton and 2 kg for synthetics. - 2 kg for synthetics. -
Page 23: Washing Programmes
Programme chart Washing programmes Type of laundry Max. Programme/ Description of and symbols on Available options load temperature programme labels 6.5 kg Wash at SPIN SPEED Cottons 60°-90°C White cotton: e.g. RINSE HOLD 60°-90°C 3 rinses sheets, tablecloths, PREWASH Long spin household linen EXTRA RINSE QUICK WASH... -
Page 24: Timed Drying
Programme table Drying Degree of Drying time Type of fabric Max. load Spin speed drying mins 3 kg 1200 Extra dry Cotton and linen Ideal for (bathrobes, bath towelling towels, etc.) materials 1.5 kg 1200 3 kg 1200 Cotton and linen (towels, T-shirts, bathrobes) Store dry... -
Page 25: Maintenance
Maintenance 1. Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold. 2. Bodywork Clean the outside of the machine with warm water and a neutral, non-abrasive household detergent. Rinse with clean water and dry with a soft cloth. -
Page 26: Water Inlet Filter
5. Water inlet filter 7. The dangers of freezing If you notice that the machine is taking longer to fill, If the machine is exposed to temperatures below check that the filter in the water inlet hose is not 0°C, certain precautions should be taken. blocked. -
Page 27: Something Not Working
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10: problem with the water supply - E20: problem with water draining - E40: door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. - Page 28 Problem Possible cause • Spinning starts late or the • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in laundry is not spun enough: the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.