Use; Control Panel; Controls - Zanussi FA615E User Manual

Use

Control panel

1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons: PRELAVADO or LEJÍA;
DIARIO; SUPER ACLARADO and ANTIARRUGAS
must be selected after the required programme has
been chosen, by turning the programme selector
(see section 8) and before starting the machine, by
pressing INICIO / PAUSA button.
2. PRELAVADO OR LEJÍA button
By pressing this button you have the possibility of
choosing between the following options:
• PRELAVADO option: Adds a pre-wash phase at
the start of the cycle with water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.This
option cannot be selected for WOOL.
• LEJÍA option: Runs water through the bleach
compartment at the beginning of the first rinse in
COTTON cycles.
To select the different options, proceed as
follows:
A) Press ONCE, to select PRELAVADO option,
the corresponding light comes on;
B) Press TWICE, to select LEJÍA option, the
corresponding light comes on;
C) Press THREE times, to cancel the selection,
the corresponding lights go off.
3. DIARIO button
By selecting this option the washing cycle duration is
reduced. We recommend its use for slightly soiled
cotton and synthetic fabrics.
4. SUPER ACLARADO button
Can be used with all programmes, except wool.
The machine will add 2 rinses to the selected
programme.
This option is recommended for people who are
allergic to detergents and in areas where the
water is very soft.
5. ANTIARRUGAS button
By selecting this option, the water of the last rinse is
not drained, in order to prevent the fabrics from
wrinkling. The corresponding light will remain lit
during the entire washing cycle. When the
programme has finished, FIN light will also
illuminate.
To drain the water follow these three steps:
A) Turn the programme selector dial to "
B) Select DRAIN or
C) Press INICIO / PAUSA button.
6. INICIO / PAUSA button
After selecting the required programme, by the
programme selector (see section 8), press this
button to start the machine; the corresponding
light stops flashing and will keep lighting until
the programme finishes.
To interrupt the running programme, depress
INICIO / PAUSA button: the corresponding
light starts to flash.
To restart the programme from the point at
which it was interrupted, press INICIO / PAUSA
button again.
33
O
".
SPIN programme.