Programming The Remote Control; Code Entry - Hughes HAH-SA Owner's Manual

Programming the
remote control

Code Entry

14
Using the remote control
You can operate your TV, VCR, SAT, AUX device, or DVD (HRMC-11 and
HRMC-12 only) devices using your remote control. Use the Code Entry or
Code Scanning method to program the remote control. Using the Code entry
method may be quicker, but you'll need to know the correct manufacturer's
control codes for each component you want to operate. Code scanning may be
more time-consuming, but you don't need to know manufacturer's control
codes.
1. Keep your remote control aimed at the device you want to control during
this process. The remote control will send out the "power" command for the
device being programmed.
2. Press and hold the device key (for example,
3. Press press the
MUTE
4. Release both keys.
The device key should light and remain lit. If it doesn't remain lit, repeat
steps 1 through 4 above.
5. Choose one of the programming methods described below:
Use the pane under the
REMOTE
HRMC-11, HRMC-12, or HRMC-13 remote control to operate your TV, VCR,
SAT, AUX device, or DVD (HRMC-11 and HRMC-12 only). The AUX menu
button can be used to control a CATV box or other type of device. Use the menu
buttons to choose the desired type of device and display a brand name menu list
from which you can select the manufacturer of your device.
Device codes appear in the menu pane for the brand selected. Step-by-step
onscreen help guides you through the procedure. Appendix B – Manufacturers
device control codes, on page 41 also provides a complete list of device codes.
TV
key for two seconds.
menu tab to program your
System Setup
)