Powering Up The Router - Compatible Systems MicroRouter 1220i Installation Manual

Microrouter 1220i

Table of Contents

Enlarged version

Chapter 3 - Network Installation

Powering Up the Router

Power up any modem, CSU/DSU, or TA before powering up the router.

This allows the router to immediately sense whether its secondary inter-

face is connected. The exception to this rule is when connecting an

RS232 interface to a CSU/DSU. In such a case, you must power up the

router before powering up the CSU/DSU. At power-up, the router will

take approximately one minute to become visible to CompatiView.

Note: If you want to use Telnet as a management method, you must

first configure an IP address into the router using an out-of-band

console, or reconfigure the IP address on an IP host or workstation on

the same Ethernet segment as the router. See Chapter 5 - Command

Line Management for more information.

Table of Contents

Do you have a question about the MicroRouter 1220i and is the answer not in the manual?