Download Print this page

KORTING HG 675 X Instruction Manual

Built-in gas hobs

Advertisement

Quick Links

Advertisement

loading
Need help?

Need help?

Do you have a question about the HG 675 X and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for KORTING HG 675 X

  • Page 3 HG 675 X – HG 675 CX – HG 675 CN – HG 675 CW –...
  • Page 5 93/68: 90/396: 2006/95/CE: “ ” 2004/108/CE: 1935/2004: 2002/95/CE: RoHS . .) ..)
  • Page 6 220-240 V ~ 50/60 Hz 100° C; . 1.
  • Page 7 . 2. F = 10mm G = 15mm E = 180cm² H = 50mm D = 120cm² C = 30mm . 2. (C), (B),...
  • Page 8 . 3. 1 kW (A). (A). . 4.
  • Page 9 (C), (E), – . 5. L- N-...
  • Page 10 III, 50° C T90°C). Ø 0,75 ². ½ D – E – F – . 6.
  • Page 11 (J), . 7. G30/G31 20 mbar 28-30/37 mbar , kW , kW Ø 1.00 0.30 0.72 0.50 1.75 0.44 0.97 0.65 3.00 0.75 1.15 0.85 3.30 1.50 1.24 0.91...
  • Page 12 G30/G31 . 8.1 . 8.2...
  • Page 13 . 9.
  • Page 14 . Ø, . Ø, . Ø, . Ø, – 180 - 200 . 10). . 10. . 11. “WOK” ( . 11) – «WOK» «WOK»...
  • Page 15 “E” . 12. “T” . 12), . 12...
  • Page 16 2002/96/EC, WEEE,...
  • Page 17 INSTRUCTIONS MANUAL Built-in gas hobs HG 675 X – 60 cm gas hob HG 675 CX – 60 cm gas hob HG 675 CN – 60 cm gas hob HG 675 CW – 60 cm gas hob...
  • Page 19: Declaration Of Compliance

    DECLARATION OF COMPLIANCE This appliance complies with the following European Directives: 93/68: General Regulations 90/396: “Gas Appliances” 2006/95/CE: “Low voltage” 89/336/CEE: Electromagnetic compatibility CE Regulation 1935/2004: this appliance is suitable to come in contact with food products. 2002/95/CE: RoHS directive GENERAL WARNINGS Read carefully the instructions manual before starting to use the appliance.
  • Page 20: Installation

    TECHNICAL CHARACRETISTICS Voltage and power supply frequency: 220-240 V ~ 50/60 Hz For the detailed information about the technical characteristics of the oven, see the technical data label on the back of the last page of the present manual, or the product data plate, that is located on the bottom of the appliance.
  • Page 21 Important: If the hob is installed and there is no oven below it, you need to put a separator panel between the bottom of the hob and the top of the furniture below, which should be positioned at a minimum distance of 10 mm below the hob.
  • Page 22 Figure 3. Installation area and removal of combustion fumes. The appliance must be installed and must operate in suitable areas in compliance with the standard regulations and local laws. The technician installing the appliance must observe the current laws governing ventilation and removal of combustion fumes.
  • Page 23: Electrical Connection

    The opening A must be free and keep assured that it is not obstructed from the inside or outside. Preferably position it on the floor level, on the opposite side of the fume exhaust devices. If the area does not allow such solution, the air could be supplied by an adjacent suitable ventilated room, as long as it is not a bedroom, a low-pressure area or a dangerous area.
  • Page 24: Connection To Gas Supply

    The power supply cable must be positioned in such a way that it does not exceed the room temperature by 50° C at any point. The installer is responsible for correct electricity connection and adherence to safety regulations. Before connection to the mains supply, make sure that: - the socket has a ground connection and it complies with legal regulations.
  • Page 25 Important: to connect the appliance to LPG supply, place a pressure regulator which is compliant with the current standards between the pipe and the gas tank. Attention: when finished, check that there are no gas leaks. Use soap and water or special liquids to ensure that there are no gas leaks.
  • Page 26: Using The Gas Hob

    After the adjusting operation the flame must result small, but uniform and stable all around the burner crown. USING THE GAS HOB Description of different types of hobs Figure 8.1 Figure 8.2 Control panel. Enameled grids (left and right). Cast-Iron grids (left and right). Semi-rapid burner.
  • Page 27 The ignition device must not be pressed for more that 15 seconds. If the burner does not start in 15 seconds, wait for at least 1 minute before trying again the electric ignition. Note: If the local gas supply is particularly hard to ignite, repeat the operation assuring that there is no pan on the pan support and turn the knob to the maximum setting position.
  • Page 28: Cleaning And Maintenance

    Special “WOK” support grid (Figure 11) – optional. The WOK support grid is placed on top of the triple crown burner when using a “WOK” pan, with rounded bottom. Never use a Wok pan without this special grid and never use the wok grid for flat-bottom cookware. CLEANING AND MAINTENANCE The appliance does not require any particular maintenance, except regular cleaning.
  • Page 29 TECHNICAL SERVICE AND SPARE PARTS Repairs must only be carried out by authorized personnel, especially on the electrical parts. It is recommended to contact an Authorized Service Centre, indicating the type of fault, appliance model and serial number located on the appliance data plate. The plate is located on the bottom of the appliance.
  • Page 32 H01A7510...