Yamaha SXV70H Owner's Manual page 77

Table of Contents

Advertisement

ESU00315
Control rod adjustment
For SXV70/SXV70ER
The weight transfer can be adjusted by turning the con-
trol rod adjusting nut 1.
1. Loosen the locknut 2 while holding the control rod
adjusting nut 1.
2. To increase weight transfer, turn the adjusting nut in
direction a. To decrease weight transfer, turn the
adjusting nut in direction b.
3. Tighten the locknut.
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18.1 ft·lb)
CAUTION :
@
G
When using the two 22-mm wrenches included in the
tool kit, make sure that they are situated at a right
angle to the control rod as shown, and that they are
tightly fitted to the locknut and the control rod adjust-
ing nut.
G
The left and right adjusting nuts must be set to the
same position. Uneven settings can cause poor han-
dling and loss of stability.
@
WARNING
@
Never adjust the control rods beyond the maximum
range indicated on the rods with red paint 3.
@
c Adjustable range
d Standard position
8-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sxv70erhSxv70mh

Table of Contents