Chapter 2 - Installing The Yamaha Crw2260T Chapter 2 - Drive; Crw2260T Drive Settings - Yamaha CRW2260t Series User Manual

Chapter 2 - Installing the Yamaha CRW2260t Drive

CRW2260t drive settings

Before installing the CRW2260t in your computer, you will need to set
the following jumpers.
You set these jumpers by inserting jumper connectors into the jumper
switch located on the rear panel of the CD-RW drive.
Important: Use long-nose pliers to remove or insert jumper connectors.
In the diagrams in this manual, solid black fill is used to indicate
locations where a jumper is used to short between pins.
Rear Panel
SCSI ID settings
The SCSI ID number is used so that the computer will recognize a
connected SCSI device. You can assign 0 through 7 as the SCSI ID
number. Usually, "7" is reserved for the SCSI card ID number, and "0"
is reserved for the first SCSI device in the chain.
Use a number between 1 and 6 for the CRW2260t. Refer to the diagram
below for more information on setting the SCSI ID number. The factory
set ID number is "3".
Important: If you are using other SCSI devices, be sure to use a unique ID number
for each device.
Chapter 2 - Installing the Yamaha CRW2260t Drive
SCSI ID settings
Parity setting
Terminator setting
Block size setting
49880-0
VZ
ID SELECT
PARITY
AUDIO OUT TERMINATOR
BLOCK SIZE
R G L 1 2 4
Jumper Switch
49890-0
VZ
SCSI
INTERFACE
CONNECTOR DC INPUT
+ +
1 5V G 12V
5