Breaking In (Running In) Engine - Yamaha C40A Owner's Manual

EMF50011
BREAKING IN (RUNNING IN)
ENGINE
Your new engine requires a period of
break-in (running-in) to allow mating sur-
faces of moving parts to wear-in evenly.
Correct break-in (running-in) will help
ensure proper performance and longer
engine life.
cC
Failure to follow the break-in (running-in)
procedure may result in reduced engine
life or even severe engine damage.
Break-in (running-in) time: 10 hours
Break-in (running-in) premix ratio:
Refer to "Gasoline/Petrol and Oil
Mixing".
EMU00226*
Run the engine under load (in gear with a
propeller installed) as follows.
1) First 10 minutes:
Run the engine at the lowest possi-
ble-speed. A fast idle in neutral is
best.
2) Next 50 minutes:
Do not exceed half throttle (approxi-
mately 3,000 r/min). Vary engine
speed occasionally. If you have an
easy-planing boat, accelerate at full
throttle onto plane, then immediately
reduce the throttle to 3,000 r/min or
less.
3-8
E