Handlebar Switches - Yamaha BIGBEAR YFM400NM Owner's Manual

EBU00053

Handlebar switches

1. Lights switch
2. Engine stop switch
3. Start switch
EBU00054*
Engine stop switch "
Make sure that the engine stop switch is in
the " " position. The engine stop switch
controls ignition and can be used at all
times to stop the engine, especially in an
emergency. The engine will not start or run
when the engine stop switch is turned to
" ".
"
4-5
EBU00055*
Start switch " "
The starter motor cranks the engine when
this switch is pushed.
CAUTION:
See starting instructions prior to starting
engine. (see page 6-1 for details)
EBU00058*
Lights switch "LIGHTS"
Turn the switch to "
and taillight.
Turn the switch to "
and taillight.
CAUTION:
Do not use the headlight with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
" for the low beam
" for the high beam