Yamaha VMAX VMX12R Owner's Manual page 89

1. Positive battery lead (red)
2. Starter motor lead (black)
13. Connect and tighten the positive
battery lead and the starter motor
lead to the starter motor relay.
WARNING
_
Pass the positive battery lead and
starter lead through the hole in the
ignition coil bracket as shown. Im-
proper routing of these leads could
bring about a short circuit, causing
the engine and lights to fail and pos-
sibly resulting in an accident.
_
14. Connect and tighten the negative
battery lead to the battery.
15. Install the rider seat.
PERIODIC MAINTENANCE AND MINOR REPAIR
To store the battery
1. If the motorcycle will not be used
for more than one month, remove
the battery, fully charge it, and
then place it in a cool, dry place.
2. If the battery will be stored for
more than two months, check the
specific gravity of the electrolyte at
least once a month and fully
charge the battery whenever nec-
essary.
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
EW000118
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed.
6-38
CAUTION:
_
If the breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas expelled
from the battery, the frame could
suffer structural and external dam-
ages.
_
EC000099
6