Parking Brake Adjustment - Yamaha BANSHEE YFZ350R Owner's Manual

EBU00932

Parking brake adjustment

Parking brake adjustment may be required if
the parking brake does not hold properly.
1. Fully loosen the parking brake cable
adjusting bolt locknut and the adjusting
bolt on the clutch lever.
1. Locknut
2. Loosen the adjusting bolt locknut and the
adjusting bolt on the rear brake caliper.
3. Turn the adjusting bolt on the clutch lever
so that cable length a is 46–50 mm
(1.81–1.97 in).
q w
2. Adjusting bolt
A. Cable length
NOTE:
If the cable cannot be adjusted to specifica-
tion, consult a Yamaha dealer.
4. Tighten the adjusting bolt locknut on the
clutch lever.
5. Screw in the adjusting bolt on the brake
caliper by hand until it feels tight, then
screw it out 1/8 turn. Tighten the adjusting
bolt locknut to the specified torque.
8-33
a