Cleaning And Anticorrosion Measures; Battery Care - Yamaha Z300C Owner's Manual

a remote oil tank, it may be necessary to
manually override the control unit to
completely fill the engine oil tank.
3. Change the gear oil. For instructions,
see page 60. Inspect the oil for the pres-
ence of water which indicates a leaky
seal. Seal replacement should be per-
formed by an authorized Yamaha dealer
prior to use.
4. Grease all grease fittings. For further de-
tails, see page 53.
EMU28420
Cleaning and anticorrosion
measures
1. Wash down the exterior of the outboard
motor with fresh water and dry off com-
pletely.
2. Spray the outboard motor exterior with
"Yamaha Silicone Protectant" (Part No.
LUB-SILCNE-13-00).
ECM01330
CAUTION:
If equipped Electronic Fuel Injection: Do
not spray when the engine is running. Al-
so, do not spray near the silencer and ox-
ygen sensor cover or into the engine.
Otherwise the oxygen sensor for Elec-
tronic Fuel Injection system could be
damaged.
3. Wax the cowling with a non-abrasive
wax such as "Yamaha Silicone Wax"
(Part No. ACC-11000-15-02).
EMU28430

Battery care

EWM00330
WARNING
Battery electrolytic fluid is dangerous; it
contains sulfuric acid and therefore is
poisonous and highly caustic.
Always follow these preventive mea-
sures:
Avoid bodily contact with electrolytic
G
fluid as it can cause severe burns or
permanent eye injury.
Wear protective eye gear when han-
G
dling or working near batteries.
Antidote (EXTERNAL):
SKIN - Flush with water.
G
EYES - Flush with water for 15 minutes
G
and get immediate medical attention.
Antidote (INTERNAL):
Drink large quantities of water or milk
G
followed by milk of magnesia, beaten
egg, or vegetable oil. Get immediate
medical attention.
Batteries also generate explosive hydro-
gen gas; therefore, you should always
follow these preventive measures:
Charge batteries in a well-ventilated ar-
G
ea.
Keep batteries away from fire, sparks,
G
or open flames (for example: welding
equipment, lighted cigarettes, and so
on.)
DO NOT SMOKE when charging or han-
G
dling batteries.
KEEP BATTERIES AND ELECTROLYTIC
FLUID OUT OF REACH OF CHILDREN.
Batteries vary among manufacturers. There-
fore the following procedures may not al-
ways apply. Consult
manufacturer's instructions.
Procedure
1. Disconnect and remove the battery from
the boat. Always disconnect the black
negative cable first to prevent the risk of
shorting.
2. Clean the battery casing and terminals.
Fill each cell to the upper level with dis-
tilled water.
3. Store the battery on a level surface in a
Maintenance
your battery
48