Fuel Consumption Meter; Fuel Economy - Yamaha Z300C Owner's Manual

port and starboard engines.
NOTE:
The fuel flow meter displays gallons/hour
G
or liters/hour according to operator prefer-
ence. Select the desired unit of measure-
ment by setting the selector switch on the
back of the gauge during installation.
1. Selector switch
The fuel consumption meter and fuel
G
economy meter will indicate the same unit
of measurement.
EMU26760

Fuel consumption meter

This gauge displays the total amount of fuel
consumed since the gauge was last reset.
Press the " " (mode) button repeatedly
until the indicator on the face of the gauge
points to total "
fuel consumption to zero, press the "
(set) and " " (mode) buttons at the same
time.
" (total). To reset the total
Basic components
EMU26770

Fuel economy

This gauge displays the distance per liter or
gallon when cruising, and is only for refer-
ence use by the operator.
Press the "
until the indicator on the face of the gauge
points to "
NOTE:
If twin engines are installed on your boat, the
"
gauge will only display the total fuel economy
of both engines.
NOTE:
Fuel consumption varies greatly with boat
G
design, weight, propeller used, engine trim
angle, sea conditions (including wind), and
throttle position. Fuel consumption also
varies slightly with the type of water (salt,
fresh, and contaminate levels), air temper-
ature and humidity, cleanliness of the boat
" (mode) button repeatedly
" (economy).
ZMU01751
ZMU01752
24