Replacing The Fuse; Replacing The Headlight Bulb - Yamaha TW200 Owner's Manual

Replacing the fuse

The fuse holder is located behind panel
B. (See page 6-8.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
2
1
1. Fuse
2. Spare fuse
Specified fuse:
20.0 A
CAUTION:
Do not use a fuse of a higher amper-
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU23502 age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
ECA10640

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
1. Bolt
6-34
1. Remove cowling
page 6-8.)
2. Remove the headlight unit by re-
moving the bolts.
1
3. Disconnect the headlight coupler,
and then remove the headlight
bulb cover.
EAU23812
A. (See
2
3
4
5
6
7
8
9