Changing The Brake Fluid; Drive Chain Slack - Yamaha FZS10W Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Changing the brake fluid

Have a Yamaha dealer change the
brake fluid at the intervals specified in
the NOTE after the periodic mainte-
nance and lubrication chart. In addition,
have the oil seals of the master cylin-
ders and calipers as well as the brake
hoses replaced at the intervals listed
below or whenever they are damaged
or leaking.
G Oil seals: Replace every two
years.
G
Brake hoses: Replace every four
years.
6
EAU22730

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
1. Place the motorcycle on the cen-
terstand.
2. Shift the transmission into the neu-
tral position.
3. Spin the rear wheel several times
to locate the tightest portion of the
drive chain.
4. Measure the drive chain slack as
shown.
1. Drive chain slack
6-24
EAU22760
Drive chain slack:
25.0–35.0 mm (0.98–1.38 in)
5. If the drive chain slack is incorrect,
adjust it as follows.
EAU22792
To adjust the drive chain slack
1. Loosen the axle nut and the lock-
nut on each side of the swingarm.
2. To tighten the drive chain, turn the
adjusting bolt on each side of the
swingarm in direction (a). To loos-
en the drive chain, turn the adjust-
ing bolt on each side of the
swingarm in direction (b), and then
push the rear wheel forward.
NOTE:
Using the alignment marks on each
side of the swingarm, make sure that
both chain pullers are in the same posi-
tion for proper wheel alignment.
EAU34311