Yamaha VZ150A Owner's Manual page 82

EMU01560
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing propeller, otherwise
the lower case and propeller boss may
be damaged.
8 Be sure to use a new cotter pin and
bend the
Otherwise, the propeller could come off
during operation and be lost.
1) Apply Yamaha Marine grease or
Corrosion resistant grease to the pro-
peller shaft.
2) Install the thrust washer and propeller
on the propeller shaft.
3) Install the spacer and washer. Tighten
the propeller nut to the specified
torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the pro-
peller shaft hole. Insert a new cotter
pin in the hole and bend the cotter pin
ends.
NOTE:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, then tighten the nut fur-
ther to align it with the hole.
602053
4-21
E
ends over securely.