Yamaha FZ1 Owner's Manual page 70

8. Pour the recommended coolant
into the radiator until it is full.
Recommended antifreeze:
High-quality ethylene glycol
antifreeze containing corrosion
inhibitors for aluminum engines
Antifreeze/water mixture ratio:
1:1
Coolant quantity:
Total amount:
2.4 L (2.11 Imp qt, 2.54 US qt)
Coolant reservoir capacity:
0.3 L (0.26 Imp qt, 0.32 US qt)
PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
_
G If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
G
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
G If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
_
6-18
EC000080 9. Install the radiator cap, start the
engine, let it idle for several min-
utes, and then turn it off.
10. Remove the radiator cap to check
the coolant level in the radiator. If
necessary, add sufficient coolant
until it reaches the top of the radia-
tor, and then install the radiator
cap.
11. Check the coolant level in the res-
ervoir. If necessary, remove the
coolant reservoir cap, add coolant
to the maximum level mark, and
then install the cap.
12. Start the engine, and then check
the vehicle for coolant leakage. If
coolant is leaking, have a Yamaha
dealer check the cooling system.
13. Install the panels.
6