Yamaha Roadliner XV1900AV Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
Dimmer " / "/Pass "
Set this switch to "
beam and to " " for the low beam.
To flash the high beam, press on the
low-beam side " " of the dimmer
switch while the headlight is on low-
beam.
3
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU40750
" switch Start switch "
" for the high Push this switch to crank the engine
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
EAU12460
/ "
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
". When re-
does not indicate a malfunction.
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
EAU12660
/ " when your vehicle is stopped where it
" before starting might be a traffic hazard.
" to
EAU12710
"
CAUTION:
Do not use the hazard lights for an
extended length of time with the en-
ECA10050
gine not running, otherwise the bat-
tery may discharge.
EAU41700
EAU12733
"
" posi-
3-10
ECA10061