Mounting Raid Box; Mounting Raid Box In System - Accusys ACS-76130 Manual

Mounting RAID box

The ACS-76130 RAID box can be installed inside a computer case or set up externally. This
section describes both procedures.

Mounting RAID box in system

The ACS-76130 RAID box fits into the space of two half-height 5¼-inch drive bays.
1. Remove the cover and front bezel from the
system case.
2. Feed a power cable  through the
opening.
3. Feed an SATA cable  through the
opening.
4. Connect the two cables to the connectors
on the rear of the RAID box.
5. If planning to use the ACSView GUI to
monitor the status of your RAID, you
should also connect a 3-pin RS-232 cable
to the terminal on the RAID box.
6. Insert the RAID box into the bay, and
secure it in place with the screws provided.
(If your case uses guide rails to install
5¼-inch devices, you can use them on the
RAID box.)
Turn off and disconnect all electrical power from the system before beginning
installation.
In order to provide stable power, we recommend to connect both power
connectors on the RAID box.