Fitting A Decorative Door Panel - Zanussi ZR 171 UN Instruction Booklet

Take the hinge removed from the upper part of the
appliance on the opposite side (see Fig. 4), and, using
the screws removed from the lower part, fix it to the
base of the appliance itself.
Remove and refit the other hinge on the upper part of
the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges (Fig. 4).
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side.

Fitting a decorative door panel

Important: The components needed to fit the
decorative panel have been pre-fitted on the
appliance.
The brackets are secured to the panel by means of
the 7 Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the large
top bracket by unscrewing the screws and
adjusting pins pre-fitted on the appliance door.
The small bottom bracket need not be removed.
Place the appliance in the position where it is to be
built in (Fig. 5).
The appliance is fitted with adjustable feet; screw the
front and rear feet in or out to adjust the height of the
appliance to that of the recess.
Keeping the appliance central in the recess, slide it in
until its back touches the wall.
With a tape measure (or similar instrument), measure
distance (A) between the top edge of the door and the
top edge of the decorative panel, placing it next to the
recess.
D510
A
= =
D467
Fig. 4
Fig. 5
17