Related Manuals for Zanussi ZR 171 UN
Summary of Contents for Zanussi ZR 171 UN
- Page 1 FRIGORIFERO REFRIGERATOR KÜHLSCHRANK REFRIGERATEUR ZR 171 UN LIBRETTO ISTRUZIONI INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D’EMPLOI 2222 261-06/1...
-
Page 2: General Safety
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. -
Page 3: Table Of Contents
CONTENTS Installation Positioning Cleaning the interior Location Door reversibility Fitting a decorative door panel Electrical connection Technical specification Operation Temperature regulation Fresh food refrigeration Movable shelves Ice-cube production Defrosting Maintenance Periodic cleaning Periods of non-operation Interior light Customer service and spare parts... -
Page 4: Installation
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock Important (latch) on the door or lid, be sure to make that It is essential that the appliance be connected to an spring lock unusable before you discard the old efficient earth tap. -
Page 5: Location
Location Fig. 1 This appliance is designed to be built-in to a space having the dimensions given in Fig. 1. 100-170 D506 The height of the appliance can be altered if required Fig. 2 by means of adjustable feet situated at its base (Fig. -
Page 6: Fitting A Decorative Door Panel
Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4), and, using Fig. 4 the screws removed from the lower part, fix it to the base of the appliance itself. Remove and refit the other hinge on the upper part of the appliance on the opposite side. - Page 7 Lay the panel face down (Fig. 6). Position the top bracket on the panel, making sure that there is an Fig. 6 equal distance between it and the sides and that its distance from the top edge is equal to distance (A) less 1 cm.
- Page 8 Check the position again by slackening the screws and pins then, once the best position has been Fig. 10 obtained, fully tighten all the fixings. Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket.
-
Page 9: Electrical Connection
If the appliance has been fitted into a space 870 mm high and the maximum height of the base plate is 150 Fig. 14 mm, fit the front cover plate as described in Fig. 13. If the base plate is between 150 and 185 mm high, cut it as shown in Fig. -
Page 10: Use
Operation Fresh food refrigeration Insert the plug into the wall socket. To obtain the best performance: Open the refrigerator door and turn the thermostat do not store warm food or evaporating liquids in the knob, clockwise, beyond the «O» (STOP) position. refrigerator;... -
Page 11: Movable Shelves
Movable shelves Fig. 15 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. -
Page 12: Maintenance
MAINTENANCE Interior light Unplug the appliance before carrying out any maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Periodic cleaning - unscrew the light cover securing screw. - unhook the moving part as shown in the figure. Clean the inside with warm water and bicarbonate of soda.