Related Manuals for Zanussi ZR 170 UN
Summary of Contents for Zanussi ZR 170 UN
- Page 1 FRIGORIFERO REFRIGERATOR KÜHLSCHRANK REFRIGERATEUR ZR 170 UN LIBRETTO ISTRUZIONI INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D’EMPLOI 2222 260-07...
-
Page 2: General Safety
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. -
Page 3: Table Of Contents
CONTENTS Installation Positioning Cleaning the interior Location Door reversibility Fitting a decorative door panel Technical specification Electrical connection Operation Temperature regulation Fresh food refrigeration Movable shelves Ice-cube production Defrosting Maintenance Periodic cleaning Periods of non-operation Interior light Customer service and spare parts... -
Page 4: Installation
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock Important (latch) on the door or lid, be sure to make that It is essential that the appliance be connected to an spring lock unusable before you discard the old efficient earth tap. -
Page 5: Location
Location Fig. 1 This appliance is designed to be built-in to a space having the dimensions given in Fig. 1. 100-170 D506 The height of the appliance can be altered if required Fig. 2 by means of adjustable feet situated at its base (Fig. -
Page 6: Fitting A Decorative Door Panel
Fitting a decorative door panel Fig. 5 Important: The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3.5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins pre-fitted on the appliance door. - Page 7 Once the top of the panel has been correctly positioned, fix it through the holes in the bottom Fig. 9 bracket, without tightening the screws (Fig. 9). D471 Check the position again by slackening the screws Fig. 10 and pins then, once the best position has been obtained, fully tighten all the fixings.
- Page 8 If the base plate is between 100 and 135 mm high, cut it as shown in Fig. 14 and mount as described above. Fig. 13 If the base plate is between 135 and 170 mm high, cut it as shown in Fig. 12. D519 Fig.
-
Page 9: Technical Specification
TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by 6% of the rated voltage. -
Page 10: Use
Operation Fresh food refrigeration Insert the plug into the wall socket. To obtain the best performance: Open the refrigerator door and turn the thermostat do not store warm food or evaporating liquids in the knob, clockwise, beyond the «O» (STOP) position. refrigerator;... -
Page 11: Movable Shelves
Movable shelves Fig. 15 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. -
Page 12: Maintenance
MAINTENANCE Interior light Unplug the appliance before carrying out any maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Periodic cleaning - unscrew the light cover securing screw, - unhook the moving part as shown in the figure. Clean the inside with warm water and bicarbonate of Fig.