Electrical Connection; Technical Specification - Zanussi ZR 100 H Instruction Booklet

Open both the appliance door and that of the Fig. 8
kitchen unit to approx. 90°. Place the little plates
8mm
over the runners. Hold the doors of the appli-
ance and the unit together and mark the holes.
PR34
Remove the little plates and make the holes
with a diam. of 2 mm. Replace the little platee
Fig. 9
over the runners and screw in the screws
provided (3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that
the doors of the appliance and the kitchen unit
open properly.
PR35
Fig. 10
If the appliance is to be fitted laterally to the
D
kitchen unit, it will be sufficient to loosen the
E
screws of the little plates (G), move them as
shown in Fig. 10 and then fasten them up
again. Fit the cover (H).
The doors can be opened using the sliding
D734
systempreviously illustrated, or one of the two
Fig. 11
doors can be opened by fitting the small handle
supplied as an accessory.

Electrical connection

D029
Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
TECHNICAL SPECIFICATIONS
GB
The technical data is indicated in the rating plate on the left side inside the appliance.
16