Door Reversibility; Building-In - Zanussi ZR 304 CTH Instruction Booklet

Door reversibility (Fig. 1)
Before fifflng the appliance in the kitchen
furniture and connecting it to the power
supply, if necessary, change the door
opening side (from right to left). Proceed as
follows:
1. Place the appliance on its back, putting
packing materia! between it and the floor to
avoid damaging the appliance cooling pipes.
2. Unscrew the bolts.
3. Assemble the spacers and the bolts on the
opposite side.

Building-in

Dimensions of the recess
Height 1780 mm
Depth
Width
For safety reasons, minimum ventilation must
be as shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
Installation of the appliance in a
fitted kitchen unit (F¡g. 3)
Drill the unit using a Ø 2.5 mm drill (10 mm
max. penetration);
Fix the square fitting (1) to the appliance and
apply the rubber seal;
Fit the refrigerator into the space recessing it
by 48 mm in relation to the unit base (Fig. 4).
Fix the refrigerator with the screws (2) to the
upper and lower part of the unit .
Fix the square fitting (1) to the unit column.
Snap the ventilation grid.
Insert the hinge cover (4).
550 mm
560 mm
D581
50 mm
D567
Ø 2,5
2
13mm
1
4
D740
Fig. 1
Fig. 2
min.
2
cm 200
Fig. 3
3
Fig. 4
13