Electrical Connection; Technical Specification - Zanussi ZR 304 CTH Instruction Booklet

nstructions to assemble the Fig. 5
I
refrigerator door to the kitchen
A
unit door
Position the runners (A) at the top and bottom
of the inside of the kitchen unit as shown in Fig.
and mark the position of the external holes.
After preparing the holes, screw the runners to
the kitchen unit door using 3.5x16 mm screws.
PR33
Fig. 6
8mm
Open both the appliance door and that of the
kitchen unit to approx. 90°. Place the little plates
over the runners. Hold the doors of the appli-
ance and the unit together and mark the holes.
Remove the little plates and make the holes
with a diam. of 2 mm. Replace the little platee
over the runners and screw in the screws
PR34
provided (3.5x16 mm).
For the alignment of the kitchen unit door, if
Fig. 7
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that
the doors of the appliance and the kitchen unit
open properly.
Reversibility of the freezer door
When changing the hinges of the refrigerator
door from right to left, it is also advisable to
change the opening side of the freezer door .
PR35
Please take the following steps:
Fig. 8
- Remove the door lower hinge.
- Remove the freezer door and take of the
upper hinge.
- Unscrew the catch and fix it on the opposite
side .
- Fix the upper hinge .
- Mount the freezer door on the left side and fix

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
TECHNICAL SPECIFICATIONS
GB
The technical data is indicated in the rating plate on the left side inside the appliance.
14