Accepting Changes And Exiting System Setup; Default Configuration; Tsetup Options - Toshiba Satellite 2670 series User Manual

Accepting changes and exiting SYSTEM SETUP

1. Press End to accept the changes you made.
If the changed item does not require the system to reboot, the following
message is displayed:
If the changed item requires the system to reboot, the following
message is displayed:
2. To make other changes, press N. Repeat the steps above.
3. To accept the changes, press Y.
You can press Esc to quit at any time without saving changes. TSETUP
asks you to confirm that you don't want to save your changes.

Default configuration

When you access TSETUP, the current configuration is displayed.
1. To show the default configuration, press Home.
2. To accept the default settings, press End and then press Y.
When you execute the default setting, the following settings are not
changed:
• Hard Disk Mode
• Password
• Write Policy

TSETUP options

The SYSTEM SETUP screen is divided into functionally related groups.
This section describes each group and its options.
Most functions described in this section can also be changed using
Toshiba's Hardware Setup or Power Saver Utility in Windows. The I/O
port, IRQ and DMA channel are set in Windows 98 Device Manager.
User's Manual
Are you sure? (Y/N)
Are you sure? (Y/N)
The changes you made will cause the system to
reboot.
Setup and Password Security 7-3