Unpacking & Installing - LG SolarDOM MP-9482SC Owner's Manual

Unpacking &
Installing
Unpack your oven and place it on a flat level
surface.
HIGH RACK
(For grill mode)
LOW RACK
(For microwave and
convection mode)
METAL TRAY
(For defrost)
By following the basic steps on these two pages you will be able to quickly check that your oven is operating
correctly. Please pay particular attention to the guidance on where to install your oven. When unpacking your
oven make sure you remove all accessories and packing. Check to make sure that your oven has not been
damaged during delivery.
20cm of space on the top and 10cm at the rear for proper
ventilation. The front of the oven should be at least min. 8cm/max.
22cm from the edge of the surface to prevent tipping.
An exhaust outlet is located on bottom or side of the oven. Blocking
the outlet can damage the oven.
STEAMER
STEAM COVER
STEAM PLATE
* THIS OVEN SHOULD NOT BE USED FOR COMMERCIAL
STEAM WATER
CATERING PURPOSES.
BOWL
* THIS OVEN CAN BE USED AS BUILT-IN TYPE .
(METAL TRAY)
* MUST USE THE BUILT-IN KIT THAT IS MADE BY LG ELECTRONICS.
4
Place the oven in the level location of your choice with
more than 85cm height but make sure there is at least