Classe Audio CA-200 Owner's Manual page 7

IR OUT and IN:
The CA-200 may also be turned on and off using our SSP-50 Surround Sound Processor,
utilising the IR OUT and IN jacks. To turn on your CA-200 with the SSP-50, Disconnect you
CA200 from the AC line completely, open the top cover and locate the 4 internal jumpers inside the
CA-200 (see fig. 2, page ) alongside the mosfet fuses. When facing the amplifier from the front,
remove the jumper located completely to the right and save this jumper. Re-install the top cover.
Install a mini jack into IR IN at the back of the CA-200 and plug the other end of the mini jack into
the 5VDC mini jack at the back of your SSP-50. When the Standby button of the SSP-50 is pressed,
it will now activate the turn on turn off circuitry of your CA-200. Several amplifiers may be turned
on automatically in sequence or all at once, depending upon the configuration of the jumper settings
in the amplifier. You will find these jumpers located inside the unit (see fig.2 page) alongside the
mosfet fuses. The table below tells you which jumper should be inserted or removed to obtain the
correct sequence on which you will want your amplifier to turn on.
J3 J2 J1 J0
X X X X
X X X out
X X out X
X X out out
X out X X
X out X out
X out out X
X out out out
ADRESS RC Button
0
1
2
3
4
5
0
0
Amp 1
Amp 2
Amp 3
Amp 4
Amp 5
Amp 6
Amp1
Amp 1
-7
CA-200 ISSUE 3 DEC. '97
Auto ON
No
No
No
No
No
No
No
Yes