Classe Audio CA-200 Owner's Manual page 6

MONO
Please read through the previous Stereo section for general notes on securing good
connections, and safety tips. If the unit has been previously used in stereo, make sure it is OFF, and
remove all connections, including the AC line cable. Make sure the STEREO/MONO switch is
switched to the MONO position. NOTE: The Stereo-Mono switch will not operate if the amplifier is
turned on, you will NOT be able to change from one mode to the other, as the mode is "locked"
while the amplifier is on.
The MONO "Input" is the "left channel input", as marked. The unused right channel input is
automatically disconnected. Correct output phase MONO connections are marked below the
connectors.
Repeat the above MONO settings and connections on the second CA-200 to be used for the
other channel.
Please remember that the negative output connection of a bridged amplifier is NOT a
ground. Do not use a "common ground" switch-box set-up. Do not use with electronic crossovers
which have a common ground. Connecting two bridged amplifiers to a common ground device of
any sort will cause the amplifiers to fail.
REMOTE CONTROL: (OPTIONAL)
With a simple connection from a ClassJ "Remote Interface Box" to the remote jack at the
back of the amplifier, (see Figure 1) the CA-200 can be turned ON or OFF from a distance (or from
another room). The "Remote Interface Box" repeats the information sent to the LED on the front of
the amplifier, allowing remote mounting of the amplifier.
-6
CA-200 ISSUE 3 DEC. '97