Table of Contents
Advertisement
99944200465
1. Loosen two (2) screws (A) and remove center locating
screw (B). Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean
and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.
3. Slide the flexible cable back in the drive housing. DO NOT
get dirt on the flex cable.
4. Install the gear housing and shield assembly.
5. Tighten screws securely.
Blade Replacement/Lubrication
Level 1.
Parts Required:
Blade, new split pin
Note: Grease gear case every 15 - 25 hours of use. Replace blade when carbide tips have worn away.
1. Shut engine off. Disconnect spark plug lead from spark plug.
2. Remove split pin (A).
3. Rotate blade until holes in inner blade adapter (B) and gear
box align. Insert locking tool to lock PTO shaft (C).
Note: Blade nut (D) is left hand thread.
4. Remove blade nut (D) in a clockwise direction using
T-wrench. Remove outer fixing plate (E), blade (F) and inner
fixing plate (B).
5. Clean all loose debris from gear box.
X7702096503
© 08/2013 ECHO Inc.
MAINTENANCE
A
B
C
F
E
B
D
A
17
Advertisement
Table of Contents
