Call Handling - SENDO 550 User Manual

12
Note
If the alarm activates during a call, the phone will
beep and the display will flash to indicate that the
alarm is active. As described above, press δ,
to switch it off, or γ,
ten minutes.
If the volume is set to silent mode, the alarm will
activate but there will be no sound. The phone will
still vibrate if the vibrate feature is on.
The alarm will sound even if the phone is switched
off. The phone will power on (if battery power is
available) but you will not be able to receive or make
calls. If the volume was set to silent mode before the
phone was switched off, the alarm will still sound as
silent mode is cancelled when the phone is
switched off. Once the alarm finishes, the phone will
switch off automatically.
Screensaver
A screensaver is a picture that is displayed
when the phone has been idle for a certain
amount of time. It is possible to turn this on
or off, select the delay before it becomes
active and change the picture.
When the screensaver is displayed, press
χ
to return to normal display and use the
phone.
Snooze to stop the alarm for

Call handling

Select this to set defaults for the way in
which you deal with incoming calls. The
options are as follows:
Off
Active flip
When active flip is activated, all incoming
calls are accepted automatically when
you open the phone. Closing the phone
ends a call.
Auto redial
When auto redial is activated, the phone
will automatically redial a number when
the call attempt fails. If the other user's
phone is busy, the phone will wait a few
seconds before each attempt, and then
beep when it succeeds.
Auto answer
This function is only applicable when
certain hands-free accessories (for
example, a personal hands-free headset)
are connected to the phone. When you
receive an incoming call with this feature
activated, the phone rings three times
before automatically accepting the call.
Any key answer
When this function is activated, you can
answer an incoming call by pressing any
key, except
38
δ
, Reject.