Table of Contents
Advertisement
3. MEMORY CAPACITY INDICATOR
● The number of data stored in memory is displayed graphically by
the memory capacity indicator.
● Each segment of the bar corresponds to 30 data.
* When no segment is displayed, the stored data is less than 30.
● When the memory reaches its full capacity, all the segments of
the bar are displayed.
* The 301st data and those measured thereafter will be displayed but will not
be stored in memory for later recall.
● While the data is recalled, a segment of the bar flashes to indicate
the measurement order of the data being recalled.
● A block of data contains at least three data components; block
number, measured lap/split time, starting time and date. If more
than one block of data is stored in memory, the memory may
reach a capacity limit even before the total number of lap/split
time measurement totals to 300.
4. HOW TO CLEAR THE STORED DATA
● Once the following steps are taken, all the stored data are erased from memory.
The stored data cannot be erased one by one or block by block.
● Before clearing the data, check that the stopwatch is reset to "00."
1. Press "C" to show the MEMORY RECALL display.
2. Keep "B" pressed for more than 1.5 seconds.
* While the button is kept pressed, the display shown at right appears with warning beeps.
* After 1.5 seconds, all the stored data is erased from memory with a long beep. Then, the initial
measurement display is shown.
* Unless "B" is kept pressed for more than 1.5 seconds, the stored data will not be erased from
memory.
[ Number of data in memory ]
F
291~300
When the number of
270~290
stored measurements
240~269
exceeds 290, the letter
➡
"F" starts flashing.
210~239
When the memory is at
180~209
its full capacity, the
150~179
letter "F" stops flashing
120~149
and remains displayed.
90~119
60~ 89
30~ 59
E
C
B
13
Advertisement
Table of Contents
