Kogan RELWN4AMWRA User Manual page 19

The
enough.
The wheels may not be rotating
freely.
Excessive The blade may be loose.
vibration or
noise
The blade may be unbalanced,
bent, or damaged.
Mower runs, but The battery is not fully charged.
cutting
The blade may be dull.
performance is
unsatisfactory,
or there is a loss
of power
The blade may be bent, loose, or
damaged.
The grass may be too high or too
thick for the cutting height.
The Mower is moving too fast.
Battery loses its The battery is not fully charged.
power quickly
The grass may be too high or too
thick.
The battery may be getting old.
Collection bag is The collection bag is full.
collecting grass
poorly
The grass is too long, or the
Mower is cutting too low.
The Mower is moving too fast.
The
clogged.
The mesh holes on the collection
bag are clogged.
The collection bag is wet.
battery capacity is
rear discharge may
not Charge the battery or replace with a fully charged
battery.
Remove the safety key from the socket and
remove battery, then turn the mower over on the
left side, and check the wheels for damage.
Replace with new wheels if necessary.
Remove the safety key from the socket and
remove battery, then turn the mower over on the
right side, and check that the blade is tightly
attached. If not, tighten the blade.
Remove the safety key from the socket and
remove battery, then turn the mower over on the
right side, remove the blade, and check its
condition. Replace with a new blade if necessary.
Charge the battery 5 hours to get a full charge.
Remove safety key from the socket, and remove
battery, then turn the mower over on the right
side, and check the condition of the blade.
Sharpen or replace the blade, if necessary.
Remove the safety key from the socket and
remove battery, then turn the mower over on the
right side, and check the condition of the blade.
Sharpen or replace the blade, if necessary
Raise the cutting height or narrow your cutting
swath and try again.
Slow walking pace down while mowing.
Charge the battery 5 hours to get a full charge.
You will need to charge the battery at least five
times to achieve maximum cutting time.
Raise the cutting height or narrow your cutting
swath.
The battery will need to be replaced.
Empty the collection bag, and clean it if
necessary.
Raise the cutting height.
Slow down.
be Remove the safety key from the socket and
remove battery, then turn the mower over on the
left side, and clean away any debris from the rear
discharge plate and below the deck.
Clean the collection bag.
Allow the collection bag to dry thoroughly before
using it again.
19