Removing And Attaching The Blade - Kogan RELWN4AMWRA User Manual

WARNING! ALWAYS switch off the mower, remove safety key from it's socket, and remove
battery before performing any adjustments, maintenance, blade change, or repairs to your mower.
1. Cleaning Your Mower
Periodically clean your mower to ensure peak performance.
Supplies needed:
Clean cloth or sponge
Mild soap or detergent (if needed)
Soft nylon brush (if needed)
1. Remove the safety key from it's socket, and remove battery.
2. Only use a dry cloth or sponge for cleaning of battery pack.
3. Only use a dry cloth or sponge to clean the battery pack seat.
4. Using a damp cloth or sponge with a mild soap or detergent, clean the Mower. Never use water, gasoline,
solvents, or other petroleum-based or solvent-based products when cleaning — remember, this is an
electric mower.
5. Use a soft nylon brush or non-metallic scrubbing pad to remove any clippings that have accumulated on
the underside of the deck and in the rear discharge plate. Do not use a wire brush; it will scratch and
harm the surface of your mower.
6. You may use water to clean the grass collection bag, but not the mower itself. For proper grass collection,
make sure the grass collection bag is clean and the mesh holes are not clogged. Allow the grass
collection bag to dry thoroughly before using it again.
Note: A wet grass collection bag will clog quickly and hamper grass collection.

2. Removing and Attaching the Blade

You must remove the blade to sharpen it, or to change to a spare blade. Always check the blade for
sharpness, damage, and tightness before and after each use. Replace the blade promptly if it has been bent
or damaged. Only use spare blades supplied by Kogan.
Figure 17
Maintaining and Storing
Figure 18
15