Operating Sequence - Zanussi ZTA 220 Instruction Booklet

Operating sequence

Before starting up for the first time it is advisable lo
load a few moist cloths into the dryer and to let it run
for about 20 minutes. This ensures that no dust and
dirt is left in the drum.
Drying:
Open the door.
Load the items one at a time, shaking them out
loosely and close the door.
Please check the laundry does not get caught
between the door and filter.
Press the ON/OFF button "AAN/UIT": the mains-ON
light comes on.
Depress button "LAGE TEMP." or "VERFRISSEN" if
required.
Turn the selector dial clockwise to the desired time,
in the high or low temperature section, depending on
the laundry.
Depress Start-button , the machine starts operating.
The machine stops automatically at the end of drying
programme.
If the laundry is still too damp, select a further brief
drying time, bearing in mind that during the last 10
minutes the dryer carries out the cooling and anti-
crease treatment phase.
After each use
• Switch the appliance off by releasing the ON/OFF
button "AAN/UIT":. The mains-ON light goes out.
• Clean the filters (see page 13).
11