Feet Assembly - Zanussi ZL 76 AMS Instruction Booklet

Feet Assembly

Before installing the cooker, it is necessary to assemble
the supplied feet. You can find them into the oven cavity.
1. Remove the hob pan supports, the burner caps and
crowns.
2. Carefully lean the cooker on its back (Fig. 13), paying
attention not to cause any damage.
3. Adjust the feet height. A height indicator is printed on
the last page of this Instruction book section (Fig.
14). Lean the foot on the page and make the foot
match with the indicator, then unscrew the bottom
part of the foot, until you obtain the required height.
Repeat the same operation with the other feet.
4. Screw the feet into the relevant holes indicated in
figure 13.
5. Lift the cooker in vertical position. Replace the crowns,
the burner caps and the hob pan supports.
6. If necessary, adjust the cooker horizontal levelling by
turning the bottom part of the feet, until the appliance
is completely stable (Fig. 15).
18
Fig. 13
FO 2283
Fig. 14
FO 2284
Fig. 15
FO 2285